Sump Pump Installation in Nashville and Middle Tennessee
Basement Waterproofing

Sump Pump Installation

Sump pump installation with a properly sized pit, a quality pump, a check valve, a sealed lid and a discharge line that moves water well away from the house.

A sump pump is the part of a waterproofing system that does the lifting. Water gathers in a pit, a float switch starts the pump and a pipe carries the water outside. When the pump is the wrong size, the pit is too small or the discharge ends too close to the foundation, the same water can come right back. Nashville homes with heavy clay, spring rain and sloping lots often need a pump that is planned as part of the whole drainage picture.

We look at where water enters, how fast it arrives and where it can leave. We set a pit liner at the low point, add a bed of stone, install a submersible or pedestal pump, add a check valve to keep water from falling back and fit a sealed lid. The discharge pipe runs through the rim joist and out to a buried line or a pop-up emitter, away from the footing and the neighbors. We test the float and the pump with a bucket of water and explain the switch, the alarm option and the monthly test we suggest.

Pit, pump and pipe as one system

A good pump in a poor pit or with a short discharge pipe still disappoints.

Check valve and sealed lid

These small parts keep water from cycling back and keep humid air and soil gas out of the room.

Float and switch tested

We lift the float, pour water and run a full cycle so you see it work.

Alarm and backup options

We explain water alarms and battery backups so you can add them now or later.

What is included

  • Pit and liner
  • Pump and float switch
  • Check valve
  • Sealed lid
  • Discharge line
  • Water test
Why it works

What you get with Sump Pump Installation

Sized to the water

We consider the inflow, the lift and the pipe run before choosing a pump.

Pit built right

A proper liner, stone base and level lid make a reliable sump.

Check valve fitted

It stops water from rushing back into the pit after each cycle.

Sealed lid

A lid keeps humid air, odors and soil gas out of the basement.

Discharge planned

Water is released away from the foundation and the neighbors.

Tested with water

We run the pump through a full cycle before we leave.

Try it now

Waterproofing Solution Picker Quiz

Answer a few questions about where and when water shows up to see which solutions usually fit, from gutters and drains to crawl space work.

How it works

Our process, start to finish.

  1. 01

    Call and describe it

    You tell us what you have seen, where and when, and we set a visit that fits your day.

  2. 02

    Inspect and measure

    We walk the outside and inside with a moisture meter, take photos, measure slopes and call for utility marking.

  3. 03

    Plan and approve

    You review the cause, the options and a plain written scope with every line and the schedule before anything is ordered.

  4. 04

    Prepare the site

    We handle permits, protect your property and prepare the work area, from the floor edge to the trench.

  5. 05

    Build and install

    We install drains, pumps, liners or repairs, restore floors and lawns and test every system with water.

  6. 06

    Walk through and care

    We walk the job with you, share a care guide and schedule a first checkup.

Questions

Sump Pump Installation FAQ

Submersible or pedestal?

Submersible pumps sit in the water and run quietly. Pedestal pumps sit above the pit. Our pump types page compares them.

Do I need a battery backup?

Storms can cut power. A backup is worth considering, and we cover options on our backup page.

Where should the discharge go?

Away from the foundation, onto a slope or into a buried line or drain basin, within local rules.

How often should I test it?

Many owners pour water in the pit a few times a year. We share a simple checklist.

Can you replace an old pump?

Yes. We check the pit, switch, valve and discharge line while we are there.

Next step

Get your Free Waterproofing Inspection for Sump Pump Installation.

Tell us about your property and we will call you back to set up a visit.

Or call (615) 357-7797 to talk now.

Tell us about your project

We will call you back to talk it through and set up a visit.

Prefer to talk? Call (615) 357-7797. We never sell your information.

Call NowFree Inspection